Reply To: 1633 (Tokai) Refurb
Home › Forums › Gossip – View only › 1633 (Tokai) Refurb › Reply To: 1633 (Tokai) Refurb
Ah, right! I was a bit surprised, cos the bearings on Needlespars are pretty well immortal! Um, I dunno! You need to get the holes on the fore and aft line of the boat so that the mast isn’t leaning one side or the other. I’ve used 12mm/half inch acetal (don’t have access to nylon). If you really meant to say one and a half inch thick material, that’s probably a bit thicker than most people would use, but I’m sure that won’t be a problem. The really VITAL thing is to have an effective method to make sure the mast can’t jump out of its step even if the boat is upside down (not that rare in my experience :oops: ): If the bottom of the mast gets free of the bottom step the mast will lever the deck off, causing massive damage! The way it was mostly done was to have a peg in the mast below the bottom step, and a cut out in the bottom step so that the mast could only go in and out when it was facing backwards. Now it’s quite common to either have a plate that fits above the top bearing and does up with wing nuts (excellent) or a bit of string (rubbish: it depends on remembering to tie the string up and being able tie an effective knot)
Dave













