arrowbasketcheckboxclosedocumentdownloadfacebookfoldergoogle-plusinstagramlinkedinphonepinterestsearchstartagtwittervimeoyoutube
OK Dinghy British Class Association
  • HOME
  • ABOUT
    • Overview
    • The OK Dinghy
    • The British Class Association
      • About Us
      • Association Contacts
      • Join or Renew
      • MEMBERSHIP DOCUMENTS, PSNs, & BOAT REGISTER
      • Resources
  • NEWS
    • Current Rankings
    • Results
    • Events News
    • Class News
  • CALENDAR
    • Overview
    • Venue Library
  • FORUM
  • CLASSIFIED
    • Boats
    • Sails & Masts
    • Other
    • Submit Classified Ad
  • GALLERY
  • More

    Reply To: Best Glue for split Centreboard handle?

    Home › Forums › Technical – View only › Best Glue for split Centreboard handle? › Reply To: Best Glue for split Centreboard handle?

    10th July 2012 at 12:24pm #5992
    Bill B
    Participant

    If yo8u can get the crack to open enough to get some glue in and still close it back up properly without any gaps, then I would recommend a polyurethane wood glue. Like runny honey and moisture cured. It sticks like s**t to a blanket (can get it off with acetone before it is cured) and will make a joint as strong as the original material (which is all you can do anyway). There is no mixing involved.
    You must have a good fit and you must clamp the joint (it foams when it goes off and will push a joint apart- the foamy cured stuff is not very strong).
    Martin is correct that if the crack is across the wood or if the wood won’t go back together, you are better cutting a piece out and splicing a new bit in- you can still use this glue.

    When it has gone hard the excess will have foamed up and can be scraped off.

    If there is a doubt about the strength of the handle (as in why it broke in the first place) you can sheath it in glass and epoxy or polyester. This needs a bit of practice to do properly and remember to sand off enough wood so that the finished article is not thicker than 20mm. You are allowed to put glass on to strengthen a wooden board. If you haven’t done it before or likely to do it badly then it is a waste of time and money because it won’t add much sterngth. The best bet is to make the handle properly strong with wood. If you think the handle is a weak wood – splice on a piece of harder stuff, plane it flat each side, cut back to o;ld profile, sand and paint.

    Hope this helps.

    Bill


    2026 P&B OK DINGHY SOUTHERN CHAMPIONSHIP

    Poole YC | 10-11 October 2026

    The International OK Dinghy British Class Association is proud to announce the 2026 P&B OK Dinghy Southern Championship at Poole YC from 10 - 11 October, 2026.

    NoR
    Entry

    2026 P&B OK DINGHY Eond-of-Season CHAMPIONSHIP

    Northampton SC | 24-25 October 2026

    The International OK Dinghy British Class Association is proud to announce the 2026 P&B OK Dinghy End-of-Season Championship at Northampton SC from 24 - 25 October, 2026.

    NoR
    SIs
    Entry

    LATEST NEWS & RESULTS

    News Update

    22nd September 2026

    Message from the New Chair

    10th September 2026

    2026 Ovington British OK National Championship

    7th September 2026

    P&B Eastern Championships

    28th May 2026

    Daffodil Regatta

    28th April 2026

    Entry Opens for the 2026 P&B OK Dinghy Eastern Championship

    28th April 2026

    UPCOMING FIXTURES

    • Facebook
    • Instagram
    • Flickr

    Contact

    International OK Dinghy
    British Class Association
    PO Box 1170
    Ipswich
    IP1 9HZ

    Email: [email protected]

    Copyright © 2024 OK Dinghy | Privacy Policy | Website Admin