arrowbasketcheckboxclosedocumentdownloadfacebookfoldergoogle-plusinstagramlinkedinphonepinterestsearchstartagtwittervimeoyoutube
OK Dinghy British Class Association
  • HOME
  • ABOUT
    • Overview
    • The OK Dinghy
    • The British Class Association
      • About Us
      • Association Contacts
      • Join or Renew
      • MEMBERSHIP DOCUMENTS, PSNs, & BOAT REGISTER
      • Resources
  • NEWS
    • Current Rankings
    • Results
    • Events News
    • Class News
  • CALENDAR
    • Overview
    • Venue Library
  • FORUM
  • CLASSIFIED
    • Boats
    • Sails & Masts
    • Other
    • Submit Classified Ad
  • GALLERY
  • More

    Reply To: OKDIA AGM: draft agenda

    Home › Forums › Gossip – View only › OKDIA AGM: draft agenda › Reply To: OKDIA AGM: draft agenda

    3rd June 2015 at 4:34am #8335
    bradjohanson
    Participant

    New Rule
    8.3.2 Single skin timber boats may add a layer of plywood, with a maximum thickness of 4mm, for reinforcing in the cockpit only.
    Amendment 1. Cockpit reinforcing as described in 8.3.2 may only be used in boats with no stringers.
    Amendment 2. Cockpit reinforcing as described in 8.3.2 is limited to an area of 0.90m2
    Amendment 3. Cockpit reinforcing as described in 8.3.2 may extend 50mm from the Bulk-heads at Stns 1 and 2.
    Amendment 4. The type of plywood used for cockpit reinforcing as described in 8.3.2 must be no heavier than the plywood used in the skin of the boat

    What happened to the 8.3.2 change approved at the 2014 Annual General Meeting? It does not show up in the current class rules.

    8.3.2 All framing and longitudinal stiffening, including stringers, shall be consistent throughout the boat.
    Reasoning: Again this removes a grey area on whether stringers have to run the length of the boat or not.
    Carried: 8 for (NED, POL, FRA, AUS, NZL, SWE, GBR, GER), 0 against.

    If this meant to replace that 8.3.2 or be an additional rule?

    Amendment 1 why should only boats without stringers get the benefit of a cleaner, safer, more comfortable, dryer cockpit?
    Amendment 2 this should be enough to have the extra panel tie into the two stringers each side in the rest of the hull (assuming we don’t pass amendment 1)
    Amendment 3, this makes structural sense (and I assume we can also extend the stringers past stations 1 and 2 say 150mm to make a fair transition between the stringers and the floor panel when building a boat with stringers (assuming we don’t pass amendment 1)
    Amendment 4. One builder builds a 5mm bottom and then vacumes in a light 4mm plywood inside everywhere except in the cockpit where he vacumes in a heavy 5mm plywood to meet the 10% thickness rule. Can he then add a 4mm heavy ply or 4mm light ply?


    2026 P&B OK DINGHY SOUTHERN CHAMPIONSHIP

    Poole YC | 10-11 October 2026

    The International OK Dinghy British Class Association is proud to announce the 2026 P&B OK Dinghy Southern Championship at Poole YC from 10 - 11 October, 2026.

    NoR
    Entry

    2026 P&B OK DINGHY Eond-of-Season CHAMPIONSHIP

    Northampton SC | 24-25 October 2026

    The International OK Dinghy British Class Association is proud to announce the 2026 P&B OK Dinghy End-of-Season Championship at Northampton SC from 24 - 25 October, 2026.

    NoR
    SIs
    Entry

    LATEST NEWS & RESULTS

    News Update

    22nd September 2026

    Message from the New Chair

    10th September 2026

    2026 Ovington British OK National Championship

    7th September 2026

    P&B Eastern Championships

    28th May 2026

    Daffodil Regatta

    28th April 2026

    Entry Opens for the 2026 P&B OK Dinghy Eastern Championship

    28th April 2026

    UPCOMING FIXTURES

    • Facebook
    • Instagram
    • Flickr

    Contact

    International OK Dinghy
    British Class Association
    PO Box 1170
    Ipswich
    IP1 9HZ

    Email: [email protected]

    Copyright © 2024 OK Dinghy | Privacy Policy | Website Admin