General Maintenance Question
Home › Forums › Technical – View only › General Maintenance Question
- This topic has 7 replies, 5 voices, and was last updated 18 years, 11 months ago by
RB.
-
AuthorPosts
-
6th December 2007 at 11:35am #291
RBParticipantI took some digital images of the inside of the front tanks/bulkhead of my OK and was pleasantly surprised of the general condition given the boat was built in 1980. The question is, and I suspect the answer is fairly obvious, to carry out any maintenance in the front half of the boat I take it would mean removing the foredeck in its entirety? Not that I need to yet but there will come a time as with all things that general maintenance will dictate. How do the all plastic boats manage if they have a problem in the front end under the deck? This problem has always been at the back of my mind because the two little inspection hatches I have on the front bulkhead leaves very little if no room at all to carry out maintenance.
Thanks
Richard OK -1946
7th December 2007 at 6:13pm #2562
andyt15064ParticipantRichard – taking the deck off is a lst resort and a recipe for not having your boat on the water for quite a long time.
You are allowed up to 3 hatches per buoyancy compartment. You could enlarge to 5″, or even 8″ the hatches you have already got and put a new one next to the mast step which helps when looking at the bottom mast step and bearing with the mast in situ.
Andy
7th December 2007 at 8:06pm #2563
RBParticipantAndy,
Many thanks.
Do you know where you can obtain 8″ hatches?
Richard
7th December 2007 at 8:24pm #2564
Alan PriceParticipantRichard.
Take a look athttp://www.holtperformance.com
Follow “deck hardware” link to “hatch covers” then “product table”
Armed with a part number of the required hatch, I should think any Holt stockist would be able to order you one if they did not have it on the shelf.
But if your inners are as good as you say, why start sawing holes in your decks just yet? Access will not be problem if and when it is needed. Do’nt worry.7th December 2007 at 8:50pm #2565
Bob EastwoodParticipantOh dear, oh dear! What have I started? Time to leave the country I think.
Have a good winter ripping decks off etc. chaps.7th December 2007 at 9:11pm #2566
RBParticipantno,no,no,no,……stop,stop,stop!!!! I have absolutely no intention of removing decks et al all I wanted to know was how on earth would someone carry out maintenance under the deck of an OK if something broke, rotted or required gluing ……. nothing more than that. As said in my first post everything is very hunky dory under the foredeck of 1946 and long my it last .
Richard
8th December 2007 at 11:21pm #2567
davecooperParticipantIsn’t your boat composite, Richard? If so, I wouldn’t expect anything very dramatic to go wrong up the front. Wooden boats sometimes have a problem with the front of the cb box splitting: Alex’s last boat, 2021 had it happen at Grafham one day, and my boat’s done it sometime in the past and been repaired. Provided you don’t leave them full of water and bow down (mast step goes rotten ) there don’t seem to be much else except battle damage to worry about.
DavePS 1918 had big hatch covers in the cockpit. They weren’t Holt. I think they were Seasure. Anyway, I couldn’t get a decent grip on them and if I accidentally did them up a bit tight I had to tap them undone with a rubber mallet – not so good if I’d put my sandwiches inside!!
9th December 2007 at 6:41am #2568
RBParticipantThanks Dave,
Yes she is composite and always stored nose up and lovingly cared for
-
AuthorPosts
- The forum ‘Technical – View only’ is closed to new topics and replies.













