Weighing a Hull?
Home › Forums › Technical – View only › Weighing a Hull?
- This topic has 6 replies, 5 voices, and was last updated 14 years, 1 month ago by
hughsheehy.
-
AuthorPosts
-
10th September 2012 at 8:52pm #941
RichParticipantHi
There is an old (early 70’s) all GRP OK which I have been contemplating restoring. However to me the hull feels VERY heavy having been left uncovered for the last 6 years. I was therfore wondering if there was a method by which I could to get an approximation of the hull weight using bathroom scales, as I fear this old girl may now be too heavy even for club sailing to warrant the effort of restoration. One method suggested to me was to weigh as follows:
Put boat on trollytrailer
Put bathroom scales under one wheel – note weight
Repeat under other wheel – note weight
Repeat under trolleytrailer nose – note weight
Add 3 weights together = Total YTake boat off the trolleytrailer and repeat the above process
Add up the 3 weights = Total XDeduct total X from total Y = Hull weight
Not sure if this is right or not?
Cheers
Rich10th September 2012 at 9:07pm #6170
davecooperParticipantSounds fine. I think the ground should be fairly flat. I’m wondering why an all-grp boat should have absorbed a lot of water? After all, grp cruisers stay afloat all the time and AFAIK don’t put on a terrific amount of weight.
Dave11th September 2012 at 7:19am #6171
RichParticipantThanks for that Dave, I will try putting the scales on a peice of plywood to get things as level as I can.
It is possible that the boat may not be as heavy as I think it is, as it’s a few years since I last had an OK and the memory is not what it was. However I did get the distinct impression that it was heavier than my old wooden Phantom which I have always understood to be around the 75kg mark.
11th September 2012 at 9:32am #6172hughsheehy
ParticipantFrom what I remember of my composites theory (it’s been a few years) then unless it’s been immersed it won’t have absorbed much water. Even hulls in water typically absorb only a couple of percent so you might have a kilo of water in the laminate. And that will come back out if you dry the boat.
I’ve seen hulls (not OKs, but GRP) with kilos of moss in them that came up quite well once cleaned and dried.
h
11th September 2012 at 1:39pm #6173
bob193Participantrich the standard way in the phantoms used to be with the hull upside down place bow on a pivot (chair ,bench, etc) and the scales under the transom, note weight and then reverse the procedure transom on pivot scales under the bow then add the 2 weights together
11th September 2012 at 7:57pm #6174
leechParticipantDoes this really work? If I weigh myself on the scales with one foot on the floor and then the other it doesnt work!
10th October 2012 at 11:34pm #6175hughsheehy
ParticipantBy the way…in an answer to the original poster’s question. Look at this page.
http://windmillclass.myfleet.org/static/weigh.html
H
-
AuthorPosts
- The forum ‘Technical – View only’ is closed to new topics and replies.













